CS 2734 Computer Organization II

In this laboratory you will explore exception handling in MIPS.

• Make a new directory for the assignment.

• Download the following files:
  • The test program instructions.s
  • The default handler (with extra comments) trap.handler

• Execute the instructions.s program under spim:

        spim -file instructions.s
  

  The program should generate six Bad Data/Stack Address Exceptions (Exception 7) because the program assumes that the data segment starts at 0 and xspim assumes that it starts at 0x10000000.

• Run the instructions.s program again using xspim and this time single step through at least two exceptions. Make sure you see how the flow of control is changed by looking at the source code and note where the exceptions occur.

        xspim -file instructions.s
  

• Modify instructions.s to a MIPS program instr_good.s by changing two instructions so that it runs correctly. (The program should form the sum A[0] + A[1] + ... + A[8] = 0 + 1 + 2 + ... + 8 = 36 and print this number. Make no further use of the file instr_good.s below.)

• At the bottom of the test program instructions.s, add the default handler code trap.handler:

       cat instructions.s trap.handler > instr_trap.s
    

  Run xspim using the following command line. (Don't forget the -notrap option, or Spim will load both the default handler and the one you concatenated at the end.)

       xspim -notrap -file instr_trap.s
  

  You can also try out spim:

       spim -notrap -file instr_trap.s
  

  The program should run the same way it did before.

• Now edit the trap handler trap.handler so that it handles a bad data/stack address (Exception 7) as follows. (If you wish you can just directly edit the file instr_trap.s, say, to produce a file instr_trap_fixed.s.)
  • Print a special new message indicating that you are adjusting for exception 7.
  • Add 0x10010000 to $t1.
  • Restart the current instruction. (Note: Restart the current instruction, not the next instruction as the current handler does.)

  When you run the program you should only get two Exception 7 occurrences at the instructions:

          lw      $t4, 84($t1)    #Constant 4 stored in $t4
  
             ....
          sw      $t3, 0($t1)     #sum is stored
  

  Your program should handle these exceptions so that the correct calculation is performed and a 36 is printed at the end.

• Debugging hints:
  • You will probably need to do a lot of single-stepping to debug.
  • Be sure to use addu when adding addresses so that you don't generate an overflow exception.
  • Be very careful not to use any registers in your trap handler that you haven't explicitly saved in kernel static memory. It is best to just use the register $a0 for all your work.
  • Note that when the exception error message is printed by the handler, register $k0 holds the exception number 7, but it is shifted 2 positions to the left, so that $k0 actually holds 28 = 0x1c = 11100 (base 2).
  • You should NOT modify the original code instructions.s at all. The original bad data address references should remain. All modifications occur in the edited handler.